Audiovox Xpress XMB10 User Manual page 7

1. Battery Installation
Your Boom Box can operate independently of AC
power by installing 8 C-Cell batteries as follows:
NOTE: The batteries are bypassed automatically
whenever the supplied AC Adapter is
plugged into the DC 12V jack on the back
panel.
COVER LATCHES
BATTERY
COMPARTMENT
COVER
NEGATIVE
BATTERY
COMPARTMENT
(COVER REMOVED)
POSITIVE
1. Turn the Boom Box upside down to access
the battery compartment.
2. Push the battery cover latches forward and flip
up the battery compartment cover to the open
position.
3. Insert eight (8) C-Cell batteries observing
battery polarity as shown; then close the cover.
2. Cabling Interconnections
You can begin to enjoy Xpress XM
as soon as the Receiver and Boom Box Kit installation
are complete. Set up your Audiovox XMB10 by following
theinterconnect diagram.
3. Installing the Receiver in the XMB10
Install the receiver as follows:
BOTTOM OF
BOOM BOX
IMPORTANT: Make sure boom box power is off before
a. Press the EJECT button at the top of the XMB10; the
POSITIVE
spring-loaded mounting plate will tilt forward.
RECEIVER
COMPARTMENT
NEGATIVE
MOUNTING
PLATE
CONNECTOR
GUIDE PIN
-7-
®
Satellite Radio
installing and removing the Xpress
Receiver.
MOUNTING
EJECT BUTTON
PLATE
DETENT
Xpress
RECEIVER
CONNECTOR
128-7546
7 of 16