Audiovox Xpress XMB10 User Manual page 6

is also located on the front panel. When the Xpress
Receiver is installed in the boom box, the
1. PHONES Jack: Accepts a stereo headphone jack
to provide private listening capability for the Boom
Box.
2. AUX Jack: Accepts an audio input signal from an
external audio device. When using the AUX audio
input, turn the Receiver off to preserve battery power.
Adjust the volume level of the external audio device
to obtain an audio output from the XMB10. The
volume control on theexternal audio device
should be set to mid-range.
3. VOLUME +/- Pushbuttons: Increase or decrease
the volume of the audio output signal from the
XMB10. To increase the
volume level, press
the + pushbutton; to
decrease the volume
level, press the
- pushbutton.
®
6
2
1 3 4
5
-6-
NOTE: The Volume buttons on the Remote Control
unit (included w/Receiver Combo) will also
control the volume output of the Boom Box.
4. Power On/Status/Low Battery LED: The LED
lights blue when the Power On/Off pushbutton is
pressed to apply power to the XMB10. When
operating on AC current, the LED will briefly flash
approximately every 10 seconds. When operating
on DC(batteries) current, the LED will briefly flash
approximately every 5 seconds.
The LED will also indicate the status of the
volume pushbuttons when the AUX Jack is in use;
the LED will flash each time the Volume + or -
button is pressed until the maximum setting is
reached in either direction. Then the LED will
resume power source flashing as before.
5. Power On/Off Switch: When pressed, applies
power to the Boom Box; the power on LED
indicator (4) lights blue.
6. EJECT Button: Press this button to release the
spring-loaded XMB10 mounting plate to install and
®
remove the Xpress Receiver from the Boom Box.
128-7546
6 of 16