Page 1
'P1f,~ "'l-te4. Transmitter Transmitter The transmitters included in the security system kit are pre-programmed factory, with button # 1 assigned to channel one only. arrangement is listed below. To program channel 2 and 3, please follow the programming instructions listed on pages two and three of this manual. Factory Settings .Some of the more common accessories for these channels are;...
Page 2
These factory programmed settings can be prioritized based on an individual's frequencyof use, (i.e. pressing both buttons simultaneously arm/disarm etc.) by following the normal programming Please note when changing the button sequences necessary to perform steps 5, 9, and 12 three times using "transmitter A", followed by one time using "transmitter B".
Move the valet/bypass switch on, then off again. The dash mounted L.E.D. will flash 2 times, and the siren will "chirp" one time, indicating that the system is ready to accept programming for channel 2, or the pulsed ground output for remote trunk release, remote car starter, etc. You can assign anyone of the two remaining button functions listed in 4a, 4b, or 4c above to operate channel 2.
BATTERY The transmitter incorporates a small red L.E.D. built into the case. This L.E.D. can be used to indicate battery condition. You will notice a decrease in transmitter range as the battery condition deteriorates. 1. Remove the transmitter cover by removing the small screw from the back of the transmitter case.
Page 5
The cost per transmitter is $65.00 Enter total amount enclosed here $ (N. Y. State residents only: Include appropriate state sales OOose check or money order (do not send cash) payable to: Audiovox ~.or~ail this form and your payment to: STATE ZIP CODE...
Page 6
Audiovox Corporation 150 Marcus Blvd. Hauppauge, N. Y. 11788 Form No.128-4204 128-4204...