Audiovox Pursuit Series Manual

Hide thumbs Also See for Pursuit Series:

Download this manual

Transmitter Programming Guide

This transmitter is designed for use with your upgrade

remote start unit and is programmed by using the remote

start's program switch in combination with the transmitter

button. This transmitter can be used with any Audiovox unit

color coded with an Orange LED in the receiver.

To program this transmitter into your remote start upgrade

unit:

1) Turn the ignition to the on position.

2) Press and release the programming switch 3 times.

3) Press and hold, for 3 seconds, the button of the transmit-

ter you wish to add until the parking light flashes indicating

the transmitter has been learned.

4) Repeat step 3 for each transmitter up to a total of 4.

Turn the ignition off to exit the program mode.

NOTE: Do not allow more than 15 seconds to lapse between

steps or the program mode will be automatically exited and

you will have to start over.

If you notice decreased operating range or if the LED fails to

light when activating the unit, the batteries will need replace-

ment.

Model 09XR2PR

128-8859

1 of 4

Page 1 This transmitter can be used with any Audiovox unit color coded with an Orange LED in the receiver. To program this transmitter into your remote start upgrade unit: 1) Turn the ignition to the on position.
Page 2 Battery Replacement After removing the two #0 point phillips screws shown, pry apart case with the edge of a finger nail or a small common screwdriver. Keep hold of the metal key ring loop to prevent its loss as it will separate from the transmitter case.
Page 3 Credit Card Expiration Date: ____/___/____ 8) Mail this form along with your payment to: Transmitter Ordering Dep artment Audiovox Corporation 150 Marcus Blvd., Haupp auge N.Y. 11788  Credit card purchasers can order additional or replacement transmitters by phone. Simply dial 1 - 800 - 645 - 4994, and follow the instructions from the operator interface.

09xr2pr