Controls And Their Function - Harman Kardon SUB-TS1 Technical Manual

Amplifier/Subwoofer
SUB-TS1
FUSE
2A/250V
TYPE T
FUSE
~
AC 120V ,60Hz
160W
9
1. Speaker Level Outputs - Connect the Left, Center
and Right speakers to these connectors.
2. Speaker Level Inputs - These High Level Inputs are
for receivers that do not have line-level "pre-amp out"
or "subwoofer out" jacks. When a pair of main or
satellite speakers are attached to the OUTPUT
terminals, they are driven the full range of frequencies
as generated by the music source (receiver, amplifier,
etc.)
3. Line Level Input - These left and right Line Level
Inputs are normally used when the receiver/ processor
has line-level "pre-amp out " or "subwoofer out" jacks.
4. Auto/On Switch - This switch allows you to set the
Mode of the Amplifier. Turn the switch to Auto to
cause it to Auto-matically turn on when it receives a
signal and Auto-matically turn off after twenty minutes
without a signal. If this switch is left "On", the
subwoofer will always be ON when the power switch
is turned On, regardless of input signal.
Harman Kardon

CONTROLS AND THEIR FUNCTION

STAND BY
POWER
ON
8 7 6
L
C
R
L
C
R
LINE LEVEL
INPUT
R
SUBWOOFER
LEVEL
MIN
5
5. Subwoofer Level - This knob controls the volume
level of the SUB125.
6. LED - Red & Green. The LEDs indicate the Mode
status that the subwoofer is in. When the SUB125 is
turned OFF neither LED will be lit.
will light when the SUB125 is ON and receiving a
signal. The Red LED will light when the amplifier has
not received a signal for twenty minutes. The
subwoofer will turn on when your receiver/amplifier
begins playing again.
7. Power Switch - This the master power switch. Use it
(in Off mode) to disconnect power to the amplifier.
8. Fuse - Use only same type of fuses. For the U.S.
120V version use only a 2A 250V fuse. For the
European 230V version use only a 1A fuse.
9. AC Cord
SUB-TS1
SPEAKER
1
LEVEL
OUTPUT
SPEAKER
2
LEVEL
INPUT
3
L
ON
4
AUTO
MAX
The Green LED
5