Harman Kardon SUB-TS1 Technical Manual page 4

Amplifier/Subwoofer
Signal Sensing (ATO)
Auto-Turn-On (yes/no)
ATO Input Frequency
ATO Level
ATO Bandwidth
ATO Turn-on time
Auto Mute/ Turn-OFF Time
Power on Delay time
Transients/Pops
ATO Transient
Turn-on Transient
Turn-off Transient
Efficiency
Stand-by Input Power
Power Cons.@rated power
Protection
Short Circuit Protection
Thermal Protection
DC Offset Protection
Line Fuse Rating
Harman Kardon
yes — functional
50 Hz functional
2 mV functional
5k Hz functional
5 ms functional
20 minutes functional
3 sec. functional
5 mV-peak 10
50 mV-peak 100
50 mV-peak 100
10 Watts n/a
160 Watts n/a
Yes — functional
65 deg. — functional
C
yes — functional
2 Amps 2
2mV@50Hz into Line Input
w/ 1 ch. driven
ATO-LPF for noise DV1 measured 7mV @
immunity 5kHz.... 2mV @ 1kHz
Amp connected and AC on, then input signal applied
T before muting, after
signal is removed
AC Power Applied
@ Speaker Outputs
@ Speaker Outputs AC Line cycled from OFF to
ON
@ Speaker Outputs AC Line cycled from ON to
OFF
@ nom. line voltage
@ nom. line voltage
Direct short at output
@1/8 max unclipped DV1:Plate=50deg.C
Power max.Tab=90deg.C max.T-on
=65deg.C
DC present at Speaker Relay or crowbar (for
Out leads driver/fire protection)
Type-T or Slo Blo External fuse with UL/SEMKO
rated holder
SUB-TS1
4