Connect Using The Serial Port - Cisco expressway ce1100 Installation Manual

Cisco Expressway CE1100 Appliance Installation Guide
Configure
Table 3 Rear Panel Ports (continued)
8 LAN 3
LAN 4
9
10 VGA video port (DB-15)
Figure 2 Front Panel Showing KVM Connector
Table 4 Front Panel Ports
1 KVM connector

Connect Using the Serial Port

1. Connect the Ethernet LAN cable from the LAN 1 port on the rear of the unit to your network.
The LAN 1 port is the left-hand port of the dual port adapter on the rear panel of the unit (shown in
Rear Panel Showing Ports, page
2. Connect a serial cable from the serial port on the rear of the unit to the serial port on a PC (see
Panel Showing Ports, page
The serial cable used must be a cross-over cable. The pin assignment for the serial cable is:
Male RJ45 pin
1
2
3 TXD
4 GND
5 GND
6 RXD
7
8
Note: If there is no DB9 port on your PC, a DB9 to USB serial port adapter is required.
10).
10).
Female DB9 pin
8
6
2
5
5
3
4
7
11
Figure 1
Figure 1 Rear