Declaration Of Rohs Compliance; Fcc Compliance - Zte f160 User Manual

Hide thumbs Also See for f160:
Table of Contents

Advertisement

C h a p t e r

Declaration of RoHs compliance

To minimize the environmental impact and take more responsibility to the earth we live in, this document
shall serve as formal declaration that the ZIP 188 manufactured by ZTE CORPORATION is in
compliance with the Directive 2002/95/EC of the European Parliament - RoHS (Restriction of Hazardous
Substances) with respect to the following substances:
1. Lead (Pb)
2. Mercury (Hg)
3. Cadmium (Cd)
4. Hexavalent Chromium (Cr (VI))
5. Polybrominated biphenyls (PBB's)
6. Polybrominated diphenyl ethers (PBDE's)
The ZIP 188 manufactured by ZTE CORPORATION, meets the requirements of EU 2002/95/EC.
C h a p t e r

FCC Compliance

FCC Compliance(FOR PART 15B/PART 15C)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/ TV technician for help.
NONE PART 15B/PART 15C is as below
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device
22
23
Confidential and Proprietary Information of ZTE CORPORATION 79

Advertisement

Table of Contents
loading

Table of Contents