Vitocrossal 300 CA3 Series 2.5 to 6.0 Operating
Scanning Information
The solar energy yield is shown in diagrammatic form.
Subject to the components connected and the settings
made, you can scan current temperatures and operating
conditions.
Information in the main menu is split into groups:
H "General"
H "Combustion controller"
H "Heating circuit 1"
H "Heating circuit 2"
H "Heating circuit 3"
H "DHW"
H "Solar energy"
H "Reset data"
H "Opening source licenses"
H "Service address"
Note: The assigned name will appear if heating circuits
have been designated.
See chapter "Naming heating circuits".
Detailed options for calling up data on individual groups
From the home screen tap the following buttons:
1. "Menu"
2. "Information"
Scanning the solar energy yield in conjunction with solar
thermal systems
Only in connection with solar control unit, type SM1.
There you can scan the solar energy yield in conjunction
with a Vitosolic solar control unit.
From the home screen tap the following buttons:
1. "Menu"
2. "Solar energy"
Tap on the respective day of the week if the figure is to
be displayed as a numerical value.
Note: For further scanning options, e.g. for the solar
circuit pump hours run, see the extended menu
under "Information" in the "Solar" group.
Service address
If your heating contractor has entered their details, you
can scan these.
From the home screen tap the following buttons:
1. "Menu"
2. "Information"
3. "Service address"
Note: If there are no details, tap the white field. This will
display the keypad; see keypad diagram on page 29.
You can enter contact details.
Scanning
31