Language Selection; Setting The Measuring Units; Restoring Factory Settings - Viessmann VITOCROSSAL 300 Operating Instructions Manual

Further Adjustments

Language Selection

Setting the Measuring Units

Restoring Factory Settings

System setting
"Heating circuit 1", "Heating circuit 2" or "Heating circuit 3"
30
Vitocrossal 300 CA3 Series 2.5 to 6.0 Operating
From the home screen tap the following buttons:
1. "Menu"
2. "Settings"
3. "Language"
4. Required language
5. Tap OK to confirm
From the home screen tap the following buttons:
1. "Menu"
2. "Settings"
3. "Measuring units"
4. "Metric" or "Imperial"
5. Tap OK to confirm
Note: This must be performed on the main user interface
as well as all service displays.
You can make the following settings only at the system
and lead control boiler section 1.
You can individually restore all modified values for each
heating circuit to their factory setting.
From the home screen tap the following buttons:
1. "Menu"
2. "Settings"
3. "Factory settings"
4. "Heating circuit 1", "Heating circuit 2" or "Heating
circuit 3" as the required heating circuit
5. Tap OK to confirm
Settings and values that are reset
H Room temperature target
H Reduced room temperature target
H Operating program
H DHW temperature target
H Time program for central heating
H Time program for DHW heating
H Time program for DHW recirculation pump
H Heating curve slope and shift
H Comfort and energy saving functions are deleted.
Note: If heating circuits have been designated, the
assigned names remain intact.
See "Naming Heating Circuits" page 29.