Routing And Smoothing Edges Flush, Trimming Overhanging Material - Festool CONTURO User Manual

Routing and smoothing edges flush, trimming overhanging material

1
First trim the overhang from the edging using the MFK 700 so that it is flush with the panel. Practical: the extractor hose is
attached directly at the tabletop and does not pose an obstacle when guiding the machine. The ball bearing guide brake ensures
perfect, streak-free working results.
3
To achieve a clean, rounded finish, move the edge router
towards the edging with the cutter rotating and trim the
overhang as well as the radius.
5
If the cutter leaves impact marks during the routing process,
you can smooth them over using the scraper.
2
4
You can remove any remaining overhang using the scraper.
NOTE Special classic ogee cutters with reversible blades
are available for the MFK 700 Basic with radii of 1, 1.5, 2 and
3 mm. Suitable for edging thicknesses of 1, 1.5, 2 and 3 mm.
3
47