Spektrum DX6i Manual page 72

Rotate the roller to select the desired master channel.
Press the roller to deselect the master channel then rotate the roller to select the slave channel.
Press the roller to access the slave channel selection.
Rotate the roller to select the desired slave channel.
Rotate the roller to highlight the desired rate and direction.
Press the roller to access the rate value.
Using the roller, rotate to adjust the desired mixing values. Note that positive (+) and negative (-) values are
available and affect the direction of the slave servo travel.
After the desired value is programmed press the roller to deselect the value.
72
Reduce photo to 13.5%
MIX 1
THRO≥ THRO ACT
RATE D 0% U
SW AIL D/R TRIM ACT
List
0%