Roller Sunblind - Mercedes-Benz S-CLASS 2017 Operator's Manual

Panorama roof with power tilt/sliding panel
98
The MAGIC SKY CONTROL voltage transformer
is stamped with a high-voltage symbol, warning
you about the high voltage. The electric cables
of the high-voltage section are color orange.
Operating MAGIC SKY CONTROL from
the front
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
MAGIC SKY CONTROL switches to the status
it was set to before the engine was switched
off.
To change the degree of transparency:
X
press button :.
If the rear MAGIC SKY CONTROL element is in a
different state than the front element, the
degree of transparency will change only in the
front element. Both elements will then be in the
same state and any further changes will again
occur synchronously.
At sub-zero temperatures, the change is slower
and uneven. The entire process may take some
time.
Operating the rear MAGIC SKY CON-
TROL element from the rear
To change the degree of transparency
X
when the roller sunblind is fully opened:
press switch :.
To change the degree of transparency
X
when the roller sunblind is fully closed:
pull switch :.
The degree of transparency will change only
after the roller sunblind is opened.
If the rear roller sunblind closes when the rear
MAGIC SKY CONTROL element is not tinted, this
tints automatically.
Resetting the sliding sunroof and the

roller sunblind

Resetting the sliding sunroof or the
front roller sunblinds
Reset the sliding sunroof or the front roller sun-
blind if the sliding sunroof or the front roller
sunblind does not move smoothly.
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the 3 switch to the point of resistance
X
in the direction of arrow : until the sliding
sunroof is fully closed.
Keep the 3 switch pulled for an additional
X
second.
Pull the 3 switch in the direction of
X
arrow : until the front roller sunblind is
closed.
Keep the 3 switch pulled for an additional
X
second.
Make sure that the sliding sunroof and the
X
front roller sunblind can be fully opened
again.
If this is not the case, repeat the steps above
X
again.