Entering Basic Settings
Note
Step 6
Step 7
Step 8
Step 9
Entering Basic Settings
Using an Internet Browser
Step 1
Step 2
Step 3
Cisco Aironet Access Point Hardware Installation Guide
3-6
You cannot set the SSID without also setting the IP address. You can
set the IP address without setting the SSID, however.
Click Set Parameters.
To test the IP address, open an Internet browser.
Type or paste the Access Point's IP address in the browser's location or address
field. (If you are using Netscape, the field is labeled Netsite or Location; if you
are using Microsoft Explorer, the field is labeled Address.)
Press Enter. The Access Point's home page appears.
You can open the Access Point's management system through your Internet
browser or through the Access Point's serial port using a terminal emulator. Each
method is described below.
Follow these steps to enter basic settings with an Internet browser:
Open an Internet browser.
Type or paste the Access Point's IP address in the browser's location field. (If you
are using Netscape Communicator, the field is labeled Netsite or Location; if you
are using Microsoft Explorer, the field is labeled Address.) Press Enter.
When theAccess Point's Summary Status page appears, click Setup. When the
Setup page appears, click Express Setup.
Chapter 3
Basic Configuration
OL-0738-01