Component Locations - Whirlpool WED9500E SERIES Service Manual

COMPONENT LOCATIONS

COMPONENT LOCATIONS - WHIRLPOOL (FIGURE 1)
Drum Light
Assembly
Door Switch
(Location may vary
between models)
• Motor Assembly
• Thermal Fuse
• Outlet Thermistor
• Moisture Sensor Strips
COMPONENT LOCATIONS
Figure 16 - Component locations.
COMPONENT LOCATIONS - MAYTAG (FIGURE 2)
Drum Light
Assembly
Door Switch
(Location may vary
between models)
Light Blue
• Motor Assembly
• Thermal Fuse
• Outlet Thermistor
• Moisture Sensor Strips
(rear sensor strips not on all models)
Figure 16 - Component locations.
FOR SERVICE TECHNICIAN'S USE ONLY
For Service Technician Use Only
FOR SERVICE TECHNICIAN'S USE ONLY
Function
Start
Run
Centrifugal Switch (Motor)
Black
White
White
Light Blue
Gas Valve, Gas Dryer
NOTE: Refer to Figure 10b, page 17,
for gas dryer component locations.
Contacts
1M 2M 3M 5M 6M
=
Contacts closed
Lt. Blue
Red
Pluggable Drive Motor Switch
DO NOT REMOVE OR DESTROY
NOTE: Refer to Figure 10b, page 18,
for gas dryer component locations.
Whirlpool & Maytag 9.2 Cu. Ft. Steam Dryer
Contacts
1M 2M 3M 5M 6M
COMPONENT TESTING
• ACU
• User Interface (UI)
• Inlet Thermistor (Gas)
• Water Nozzle
• Water Valve
• Thermal Cut-off
• Inlet Thermistor (Electric)
• High Limit Thermostat
• Heater Assembly
NOTE: Refer to Figure 2, page 3-13,
for gas dryer component locations.
• ACU (beneath console)
• User Interface (UI)
• Inlet Thermistor (Gas)
• Water Nozzle
• Water Valve
• Thermal Cut-off
• Inlet Thermistor (Electric)
White
• High Limit Thermostat
Green-Yellow
• Heater Assembly
Red-White
3-3
n