Whirlpool WED9500E SERIES Service Manual page 60

COMPONENT ACCESS
Removing the Ignitor, Flame Sensor, High-Limit Thermostat
6. To remove the Flame Sensor (see Figure 4):
a) Disconnect the two (2) wire connectors from the
sensor terminals.
b) Remove the flame sensor screw from the burner
venturi and remove the sensor.
Flame Sensor
Wire Connectors
4-14 Whirlpool & Maytag 9.2 Cu. Ft. Steam Dryer
n
and Thermal Cutoff (continued)
Venturi
Screw
Figure 4
7. To remove the High-Limit Thermostat or the Thermal
Cutoff (see Figure 5):
a) Disconnect the two (2) wire connectors from the
component terminals.
b) Remove the two (2) screws from the High-Limit
Thermostat, or single screw from the Thermal Cutoff,
and remove the component from the venturi.
High-Limit Thermostat (2 Screws)
Black Wire
Thermal Cutoff
(1 Screw)
Red & Blue
Wires
Figure 5