Table of Contents
Advertisement
Searching for tape position without
picture (forward wind and rewind)
1.
1.
Stop the tape with
2.
2.
Press
REW0- s
(forward).
3.
3.
To stop the tape, press
Index search
Every time a tape is recorded an index marking
is written on the tape.
These marked positions can be found again
quickly and easily later.
1.
1.
To search for the previous marking, press
and then
INDEX 3
3
4. Manual recording
General information
Use 'Manual Recording' to make a spontaneous
recording (for example, a programme currently
being shown).
If you want to start and stop a recording manually,
read the section 'Recording without automatic
switch-off'.
If you want to start a recording manually but have
it stopped automatically, read the section
'Recording with automatic switch-off'. (e.g. not
to record to the end of the tape)
Read the section 'Direct record' if you want to
record a programme currently being shown.
Read the section 'Automatic recording from a
satellite receiver', if you want a recording to be
controlled automatically by a satellite receiver.
Recording without automatic
switch-off
1.
1.
Insert a cassette.
2.
2.
Use
PROG P+
PROG P–
gramme number you want to record, for
example, 'P01'.
3.
3.
To start recording, press
4.
4.
Stop recording with
Recording with automatic switch-off
(OTR One-Touch-Recording)
1.
1.
Insert a cassette.
.
STOP C-L
(reverse) or
FWD 1- B
STOP C-L
.
.
REW0- s
to select the pro-
.
REC I
.
STOP C-L
2.
2.
For the next marking, press
then
FWD 1- B
3.
3.
As soon as the video recorder finds this
marking, it automatically switches to playback.
Manual Tracking
To manually adjust the tracking during playback
and slow motion playback, press
or
PROGRAMME -
PROG P+
Tracking will return to Automatic Tracking
Adjustment when you press
tape, or press
PLAY B-K
To remove vertical jitter in a Still picture, press
PROGRAMME +
PROGRAMME -
2.
2.
Use
PROG P+
gramme number you want to record.
3.
3.
Press
.
REC I
4.
4.
Each time you press
minutes to the recording time.
Preventing accidental erasing
All cassettes (except rental and pre-recorded
cassettes) have a security tab on the back of the
cassette.
To prevent recording over important recordings
(erasing), you can remove this security tab.
If you later decide to record on a protected cas-
sette, simply cover the hole with adhesive tape
or slide the tab to the right.
Lining up recordings (assemble cut)
When you add a further recording to a cassette,
which already has a recording on it, a short
blank (flicker) can appear between the old and
the new recording or the picture itself can flicker.
To help reduce these from occurring, proceed as
follows:
1.
1.
Find the tape position of the old recording
where you want to insert the new recording.
2.
2.
Look at the last minute of the old recording
(playback).
3.
3.
Press
STILL
2
2
new recording is to go and press
4.
4.
Now start recording as usual by pressing
on the remote control.
REC I
5.
5.
Stop recording with
9
INDEX 3
3
.
PROGRAMME +
.
PROG P–
, insert a
STOP C-L
.
or
PROG P+
PROG P–
to select the pro-
you will add 30
REC I
at the tape position where the
REC I
.
STOP C-L
and
.
PROG P–
.
EN
Advertisement
Table of Contents
