Viewing The Status Of Your Dsr Switching System; Table 3.2: Oscar Interface Status Symbols - Avocent DSR Series Installer/User Manual

18 DSR Switch Installer/User Guide
To reset the PS/2 mouse and keyboard values:
1. If the OSCAR interface is not open, press
2. Click Commands - Reset PS/2. A message box displays requesting that you confirm the reset.
3. In the message box, click OK.
a. A message appears indicating that the mouse and keyboard have been reset.
b. Click OK to close the message box.
-or-
Click X or press
and keyboard.

Viewing the status of your DSR switching system

The status of target devices in your system is indicated in the far right columns of the Main dialog
box. The following table describes the status symbols.

Table 3.2: OSCAR Interface Status Symbols

Symbol
to exit without sending a Reset command to the PS/2 mouse
Escape
Description
(green circle) Server connected, powered up and the DSRIQ module is online.
Connected target device is powered down or is not operating properly, and the DSRIQ module
is offline.
Connected switch is online.
Connected switch is offline or not operating properly.
(yellow circle) The designated DSRIQ module is being upgraded. When this symbol displays, do
not cycle power to the DSR switch or connected target devices and do not disconnect DSRIQ
modules. Doing so may render the module permanently inoperable and require the DSRIQ
module to be returned to the factory for repair.
(green letter) DSRIQ module is being accessed by the indicated user channel.
(black letter) DSRIQ module is blocked by the indicated user channel. For instance, in Figure
3.1, user B is viewing Forester, but is blocking access to Acton, Barrett and Edie, which are
connected to the same DSRIQ module.
(blue letter) A remote virtual media connection is established to the server connected to the
indicated user channel.
to open the Main dialog box.
Print Screen