HP 5920 Series Configuration Manual page 32

# On RB 2, perform the following tasks on access-facing interfaces VLAN-interface 10 and
VLAN-interface 20:
Assign an IPv4 address to the interface.
Create an IPv4 TRILL VR and assign a virtual IPv4 address to the VR.
Enable IGMP and PIM-SM.
[RB2] interface vlan-interface 10
[RB2-Vlan-interface10] ip address 10.1.1.254 24
[RB2-Vlan-interface10] trill vr vrid 1 virtual-ip 10.1.1.1
[RB2-Vlan-interface10] igmp enable
[RB2-Vlan-interface10] pim sm
[RB2-Vlan-interface10] quit
[RB2] interface vlan-interface 20
[RB2-Vlan-interface20] ip address 20.1.1.254 24
[RB2-Vlan-interface20] trill vr vrid 1 virtual-ip 20.1.1.1
[RB2-Vlan-interface20] igmp enable
[RB2-Vlan-interface20] pim sm
[RB2-Vlan-interface20] quit
5. Configure IGMP snooping:
# On RB 1, enable IGMP snooping globally, and enable IGMP snooping and dropping unknown
multicast data on VLAN 10 and VLAN 20.
[RB1] igmp-snooping
[RB1-igmp-snooping] quit
[RB1] vlan 10
[RB1-vlan10] igmp-snooping enable
[RB1-vlan10] igmp-snooping drop-unknown
[RB1] vlan 20
[RB1-vlan20] igmp-snooping enable
[RB1-vlan20] igmp-snooping drop-unknown
# Configure RB 2 through RB 6 in the same way you configured RB 1.
6. Configure TRILL distribution trees:
# Set RB 1's priority to 65535, and set the number to 2 for TRILL distribution trees that the RB wants
all RBs to compute.
[RB1] trill
[RB1-trill] tree-root priority 65535
[RB1-trill] trees calculate 2
[RB1-trill] quit
# Set RB 2's priority to 65534, and set the number to 2 for TRILL distribution trees that the RB wants
all RBs to compute.
[RB2] trill
[RB2-trill] tree-root priority 65534
[RB2-trill] trees calculate 2
[RB2-trill] quit
28