Protection While The System Is Armed; Disarming Your System - Prestige APS-922E Owner's Manual

2 way lcd vehicle security & remote start system
Hide thumbs Also See for APS-922E:
Table of Contents

Advertisement

you should refer to the section titled "ELIMINATING THE ARM / DISARM CHIRPS"
in this manual.
 Doors Lock - Optional
Door locking during passive arming is a selectable feature. The alarm can be
programmed to allow the doors to lock only when arming using the keychain
transmitter and they will not automatically lock during passive arming.

PROTECTION WHILE THE SYSTEM IS ARMED

 Opening any protected door, hood or trunk lid will cause the alarm to immediately
sound. The alarm will continue to sound for 30 seconds, then stop and continue
to monitor all protected entry points. If the thief left a door opened, the alarm will
sound for six 30 second cycles, remain armed and ignore that triggered zone.\
 Whenever the system is armed, the dash mounted LED indicator will slowly
flash. This serves as a visual deterrent to the potential thief. The LED is a very
low current bulb and will not cause the vehicle's battery to drain, even when left
unattended for extended periods.
 Whenever the system is triggered, the vehicle's parking lights will flash for the
full 30 second alarm cycle, attracting visual attention to the vehicle.
 Optional - Whenever the system is armed, the vehicle's starting circuit will be
bypassed. If the thief should choose to ignore the siren, the vehicle can not be
started.
 Any mild impact to the vehicle's glass will cause the alarm to sound a short
series of warning tones.
 Any strong impact to the vehicle's glass will cause the alarm to trigger for the
full 30 second alarm cycle.
NOTE: If the optional interior illumination circuit was installed, the interior light will
flash as well for the full 30 second alarm cycle.
DISARMING THE SYSTEM
NOTE: If the optional 2 step door unlock circuit is installed, when the unlock
transmitter button is activated, the drivers door only will unlock, pressing the
unlock button a second time will cause all doors to unlock.
NOTE: If your transmitter has been configured with single button Lock/Unlock, to
activate the all door unlock feature operate the Lock/Unlock button a second
time within 3 seconds of the first unlock command.
1. As you approach the vehicle, press and release the Unlock/Disarm button on
the keychain transmitter.
 The dash mounted LED turns off.
The LED will start flashing rapidly, indicating that the system is re-arming
automatically. Open any door to suspend the automatic arming.
 Parking Lights flash two times.
If the parking lights flashed three times, then the alarm was triggered in your
absence. Before turning the key on, examine the LED to identify which zone was
triggered.
 Siren sounds two chirps.
Page 5
128-9363
5 of 24

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents