Step 3: Installation and Setup
GENERAL settings
(underlined options are the factory default settings)
Auto Scan
SETUP MENU - GENERAL
Auto Chapter Marker
5min.
Record Mode
SP
Timer Setting Menu
OK
Auto Scan
Search
Modify Channel
Edit
Sort Channels
OK
Manual Program
Manual Program
Program Number
P001
Name
C h 0 0 1
Standard
PAL B/G
Search Type
CHANNEL
Band
STANDARD
Frequency
172.25MHz
Fine Tuning
Delete
Ok
CANCEL
OK
OK
OK
TIPS:
Press to go access the options of an item in the menu.
Press SETUP to exit the menu.
Select to start automatic TV channel programming.
Use keys to highlight { Auto Scan - Search } and
A
press OK .
A warning message will appear.
Select
and press OK on the remote control
B
OK
OK
Use keys to highlight { Default TV System } and
press OK, Three Audio mode PAL I , PAL D/K and PAL B/G
will appear, select correct mode , then press OK.
* Hint: The set does not support NTSC TV signal in.
Use keys to highlight { CONTINUE } and press OK on
the remote control.
The automatic TV channel search will start. This process may
take several minutes. Once complete, the total number of
channels found will appear on the TV.
Select to modify your preset TV channels.
Use keys to highlight { Modify channel - Edit } and
A
press OK .
The modify channel options will be displayed.
Use keys to select one of the options and press .
B
{ Program Number } – Use CH+/ CH– to select by the program
number for modifying.
The number of the current channel, this item can not be modified
{ Name }
– Use
modifying.
{ Standard }
– Select this to set the system that produces the least
distortion of picture and sound. (See chapter "TV
System Guide" at the back of this manual for
information.)
{ Search type } –Use
Frequency and channel: To select Frequency mode,
the band item will not be display.
{ Band }
–The band of this channel, You can select standard or
cable.
{ Channel }
– Use
{ Frequency } – Select this to adjust the frequency of the channel.
– Use keys to search the next frequency or use
the Numeric keypad 0-9 to change the frequency.
Press OK on the remote control to confirm the
setting.
{ Fine Tuning }– Select this to fine-tune the TV channel manually if the
reception is poor.
– Use keys to fine-tune the frequency.
{ delete}
– Select this to set the channel to be deleted.
To confirm the changes, select
C
remote control to exit to the previous screen.
to select by the channel name for
to select scan mode, there are two mode:
to select and edit channel name.
and press OK on the
OK
OK
(continued)