Table of Contents
Advertisement
20 | HBD7S(X) Camera Configuration Guide
If ON is selected, do the following:
a.
Press the joystick to enter the TOP LEFT adjustment screen, and then adjust
the position of the selected node by moving the joystick up or down, left or
right.
b.
Press the joystick to enter the TOP RIGHT adjustment screen, and then
adjust the position of the selected node by moving the joystick up or down,
left or right.
c.
Press the joystick to enter the BTM LEFT adjustment screen, and then
adjust the position of the selected node by moving the joystick up or down,
left or right.
d.
Press the joystick to enter the BTM RIGHT adjustment screen, and then
adjust the position of the selected node by moving the joystick up or down,
left or right.
e.
Press the joystick to enter the POSITION adjustment screen, and then
adjust the position of the selected privacy mask area by moving the joystick
up or down, left or right.
f.
If you are satisfied with position and size of the privacy mask area, select
RET to save your settings and return to the PRIVACY menu. If you want to
change your settings, select AGAIN to return to the TOP LEFT adjustment
screen.
4.
Set the COLOR of the selected privacy mask area. There are 15 color options to
choose from.
5.
Set the TRANSPAR (transparency) level of the selected privacy mask area. Select
a value between 0 and 3, with 0 being the most transparent and 3 being completely
opaque.
6.
If you want, configure additional privacy mask areas by repeatings steps 2 to 5.
7.
Select RETURN to save your settings and return to the SPECIAL menu.
Defect
Note
For advanced users only.
You can set up the camera to eliminate defective pixels (white spots) on the screen.
In the SPECIAL menu, navigate to DEFECT, and then press the joystick to enter the
DEFECT menu (see
www.honeywell.com/security
Figure
17).
Advertisement
Table of Contents
