Table of Contents
Advertisement
B. Installing Vent Cap
1. Remove the four screws holding the shipping bracket to
the base of the HEAT-OUT-GAS. See Figure 2.4 and
2.5.
2. Remove the shipping bracket. See Figure 2.6.
3. The HEAT-OUT-GAS base should look like the picture
in Figure 2.7.
4. Cut a 7" diameter hole in the outside of building where
the duct for the HEAT-OUT-GAS is to be located. Refer
to Figure 2.1 for duct location on HEAT-OUT-GAS.
NOTE:
• The HEAT-OUT-GAS may be painted to a desired
color, as long as the paint selected has suffi cient
temperature and environmental ratings.
• Thoroughly sand the existing coating prior to
painting with sand paper or steel wool.
• The front of the cap cover may be fi eld-painted
and cured up to 400 degrees Fahrenheit (204°
C).
• Certain areas of the cap surface may reach up to
250 degrees Fahrenheit (121° C). Paints selected
should have suffi cient temperature ratings.
Figure 2.4
8
Hearth & Home Technologies • HEAT-OUT-GAS Instructions • 2310-939 • 3/17
Figure 2.5
Figure 2.6
Figure 2.7
Advertisement
Table of Contents
