Framing - Hearth and Home Technologies HEAT-OUT-GAS Installation Instructions Manual

2 2

Framing

A. Framing
Chassis Dimensions
The dimensions are measured as shown in Figure 2.1.
16-3/4 in.
(425mm)
13-1/2 in.
343mm)
Figure 2.1 Dimensions
Framing Dimensions
1. Construct a framework as shown in Figure 2.2.
Framework material should be the same dimensions as
the material used for the wall framing. The dimensions
of the box must be 12-5/8 inches high by 8-5/8 inches
wide.
NOTE: Framing dimensions are for mounting purposes
only and are not required for clearances.
6
Hearth & Home Technologies • HEAT-OUT-GAS Instructions • 2310-939 • 3/17
Mounting Hole
Locations
8-3/4 in.
(222mm)
2-3/4 in.
(70mm)
11 in. 3/4 in.
(279mm) (20mm)
1-1/8 in.
(53mm)
8-5/8 IN.
Figure 2.2 Framing Dimensions
10-1/8 in.
(258mm)
5-7/8 in.
(149mm)
14-1/8 in.
(360mm)
7/8 in.
(21mm)
6-7/8 in.
(175mm)
4 in.
(103mm)
12-5/8 IN.