Hearth and Home Technologies HEAT-OUT-GAS Installation Instructions Manual page 4

HEAT-OUT-GAS Configuration
NOTICE: Damper MUST be installed properly or it will not function properly.
• Vertical Mounting: Install crimped side up.
• Horizontal Mounting: Rotate so the damper closes shut when the HEAT-OUT-GAS kit is not running.
HEAT-OUT-GAS Only
**ATTACH WITH
ZIP TIE AT
DAMPER
HEAT-OUT-GAS
COLLAR
*
OPTIONAL
HEAT-OUT-GAS
LOCATION
*OPTIONAL HEAT-OUT-GAS LOCATIONS
*The HEAT-OUT-GAS may be installed in either position shown above.
*Note: Remove only one of the two HEAT-OUT seal plates if installing the HEAT-OUT-GAS.
The other plate must remain installed.
** Use included zip ties to attach the flex duct to the damper.
***Verify damper is operational and no obstructions, such as screws, are present.
Figure 1.2 HEAT-OUT-GAS Confi guration
4
***DAMPER
TYPICAL SINGLE-SIDED APPLIANCE
TYPICAL SEE-THROUGH APPLIANCE
Q
Hearth & Home Technologies • HEAT-OUT-GAS Instructions • 2310-939 • 3/17
*
OPTIONAL
HEAT-OUT-GAS
LOCATION