Eliminating The Normal Arm / Disarm Chirps - Audiovox AX-200 Owner's Manual

3 button remote security system with stage shock sensor & starter disable

Hide thumbs Also See for AX-200:

Installation manual (8 pages)

Table Of Contents

Table of Contents

NOTE:

If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then

5 seconds during any of the above steps, the unit will revert back to the last

successfully stored code.

Custom Code Programming Example:

To Change the code from the factory preassigned code of 11 to "52" you would do the

following:

1. Disarm the system by use of the transmitter, or by use of the emergency override

sequence.

2. Turn the ignition switch to the on position.

3. Within 10 seconds, press and release the valet/override switch, 3 times.

4. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will

beep and the lights will flash one time. LED turns On)

5. Within 10 seconds, begin to press and release the push button switch to set the tenths

digit. (As per the example, press and release 5 times to set the tenths digit to 5)

6. Within 10 seconds of the last press of the pushbutton, turn the ignition switch off then on.

7. Within 10 seconds, begin to press and release the push button switch to set the units

digit. (As per the example, press and release 2 times to set the units digit to 2).

8. Turn the ignition switch to the off position. Immediately observe the LED flash pattern.

You will note the LED flashing five times, pause, and then flash two times, pause. This

pattern will be repeated three times indicating the new code (52) has been accepted and

stored in memory.

NOTE:

If after step 8, the LED flashes a code other than what was just entered, this

indicates that the code has not been changed. You will have to repeat steps 1

through 7 above being certain to note the following:

Acceptable digits tens or units are 1 through 9. The unit will not recognize a 0 (Zero), or no

digit entered in any place, units or tenths.

NOTE:

If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then

5 seconds during any of the above steps, the unit will revert back to the last

successfully stored code.

MANUALLY OVERRIDING YOUR SYSTEM:

USING THE CUSTOM CODE OVERRIDE

Assuming the override code programmed has not been changed, and the default override

code of 11 is in the system's memory.

1. Enter the vehicle and turn the ignition switch to the on position.

Note:

The siren will sound.

2. Within 5 seconds, press and release the pushbutton switch 1 time.

3. Within 5 seconds, turn the ignition switch off then on.

4. Within 5 seconds, press and release the pushbutton switch 1 time.

5. Turn the ignition switch off then on and start the vehicle.

Note: If you have changed the programmed override code then substitute your new code

tenths for step 2 above, and units for step 5 above.