Mounting A Blank Panel - Fujitsu 2737 User Manual

4.8

Mounting a Blank Panel

4.8.1 One-touch type
■ Confirming components
Confirm that all components have been delivered (see the table below).
Component name
1 U blank panel
2 U blank panel
3 U blank panel
■ Mounting a blank panel
1
From the front, mount a blank panel on the rack posts (front).
Fit the mating pins of the blank panel at the following locations, which differ depending on
the size of the blank panel.
・ 1 U: Two center holes on the left and right at 1 U
・ 2 U: Two lower holes on the left and right at 2 U
・ 3 U: Two center holes on the left and right at 2 U
 The figure shows a general representation of 1 U, 2 U, and 3 U blank panels. In
actual work, select and mount the appropriate size of blank panel according to the
available space.
Type name
19R-26BP1, 1 U blank panel
19RB26BP1
19R-26BP2, 2 U blank panel
19RB26BP2
19R-26BP3, 3 U blank panel
19RB26BP3
Upper hole
Center hole
Lower hole
Mating pin
Component and quantity
1
x
1
x
1
x
After being attached
Blank panel (1 U)
Blank panel (2 U)
Blank panel (3 U)
4 Handling the Rack after Installation
E
173