Completing The Installation - Prestige APS 650 RS Installation Instructions Manual

COMPLETING THE INSTALLATION:

1. Select a desired mounting location for the program switch and the control switch. The switches may be mounted
in or below the dash by drilling a 1/4" dia. hole. Be sure to check behind the dash for adequate clearance for the
body of the switch, and to confirm that the drill will not damage any existing components as it passes through the
dash. Always try to mount these switches so that when the switch is moved to the upward position it is on (closed
to ground). Always place the red switch handle cover, (provided), on the control switch so it will be easy for your
customer to distinguish the control switch from the program switch.
2. Mount the control module behind the dash using cable ties or sheet metal screws.
3. Securely tape and tie all wiring up and away from all hot or moving objects that may come in contact with under
the dash area.
CAUTION: Particularly avoid the area around the steering shaft and steering column, as wires can wrap around
these mechanisms and impede the vehicles ability to be properly controlled.
4. Apply the Caution label included in the kit to an area in the engine compartment that is clearly visible when the
hood is opened. Make sure the surface is clean before applying the label.
5. Replace all panels that were removed during installation, and re-test the system.
6. Explain all activated features of the remote starter to the customer.