Audio Setup - Philips DVP4320WH User Manual

Tip
•
You can set or change the password, go to
> [Password].
[OSD Language]
Select an on-screen menu language.
[Sleep Timer]
Switch automatically to standby at the preset time.
• [Off] - Disable sleep mode.
• [15 mins], [30 mins], [45 mins], [60 mins] -
Select the count down time for this product to
switch to standby.
[Auto standby]
Turn on or off automatically standby.
• [On] - Switch to standby 15 minutes of
inactivity (for example, in pause or stop
mode).
• [Off] - Disable the auto standby mode.
[DivX(R) VOD Code]
Display the DivX® registration code.
Tip
•
Use this product's DivX registration code when you rent
or purchase video from www.divx.com/vod. The DivX
videos rented or purchased through the DivX® VOD
(Video On Demand) service can be played only on the
device to which it is registered.

Audio setup

1
Press SETUP.
» [General Setup] menu is displayed.
2
Press to select [Audio Setup], then press .
3
Select an option, then press OK.
4
Select a setting, then press OK.
• To return to the previous menu, press
• To exit the menu, press
14 EN
[Preferences]
.
SETUP.
[Analogue Output]
Select an analogue setting based on the audio
device that is connected through the analogue
audio jack.
• [Stereo] - For stereo output.
• [LT/RT] - For surround sound output through
two speakers.
[Digital Audio]
Select a digital setting based on the digital amplifier/
receiver that is connected through the digital jack
(coaxial/digital).
• [Digital Output] - Select a type of digital
output.
• [Off] - Disable digital output.
• [All] - Support multi-channel audio
formats.
• [PCM Only] - Downmix to two-channel
audio format.
• [LPCM Output] - Select the LPCM (Linear
Pulse Code Modulation) output sampling rate.
• [48kHz] - For discs recorded at sampling
rate of 48 kHz.
• [96kHz] - For discs recorded at sampling
rate of 96 kHz.
Note
•
[LPCM Output] setting is only available if the [Digital
Output] is set to [PCM Only].
•
The higher the sampling rate, the better the sound
quality.
[HDMI Audio]
Select the HDMI audio setting when you connect
this product and the TV with an HDMI cable.
• [On] - Allow audio output through the TV and
the speaker system. If the audio format on the
disc is not supported, it will be downmixed to
two-channel sound (linear-PCM).
• [Off] - Disable audio output from the TV.
The sound is only output through the speaker
system.
[Audio Sync]
Set the delay time for audio output when you play
a video disc.
1. Press OK.
2. Press to set the volume.
3. Press OK to confirm and exit.
[Volume]
Set the default volume level when you play a disc.