Taylor-Dunn B0-015-00 Operation, T Roubleshooting And Replacement Parts Manual page 112

Maintenance, Service, and Repair
8. Remove the shock from the vehicle.
NOTE: If the shock that was removed is to be
reinstalled:
A. Inspect the shaft where it enters the
shock body for any signs of
leakage. If any sign of leakage is
seen, then the shock must be
replaced.
B. Inspect the upper and lower shock
bushings. If any signs of damage
or wear are seen, then the shock
must be replaced.
9. Install the shock in reverse order.
10. Lower the vehicle.
11. Reconnect the main positive and negative cables
at the batteries.
12. Remove the blocks from behind the wheels.
13. Release the parking brake and test drive the vehicle.
Suspension Page 8