[Analogue Output]
Select an analogue setting based on the audio
device that is connected through the analogue
audio jack.
•
[Stereo] - For stereo output.
•
[LT/RT] - For surround sound output
through two speakers.
[Digital Audio]
Select a digital setting based on the digital
ampliÀ er/receiver that is connected through the
digital jack (coaxial/digital).
•
[Digital Output] - Select a type of digital
output.
•
[Off] - Disable digital output.
•
[All] - Support multi-channel audio
formats.
•
[PCM Only] - Downmix to two-
channel audio format.
•
[LPCM Output] - Select the LPCM (Linear
Pulse Code Modulation) output sampling
rate.
•
[48kHz] - For discs recorded at
sampling rate of 48 kHz.
•
[96kHz] - For discs recorded at
sampling rate of 96 kHz.
Note
•
[LPCM Output] setting is only available if the [Digital
Output] is set to [PCM Only] .
•
The higher the sampling rate, the better the sound
quality.
[Volume]
Set the default volume level when you play a
disc.
1. Press OK .
2. Press
to set the volume.
3. Press OK to conÀ rm and exit.
[Sound Mode]
Select a preset sound effect to enhance the
audio output.
•
[3D] - Select a virtual surround sound
effect that is produced from the left and
right audio channels.
20
EN
•
[Movie Mode] - Select a sound effect for
movies.
•
[Music Mode] - Select a sound effect for
music.
[Night Mode]
Make loud sound level softer and soft sound
level louder so that you can watch the DVD
movies at a low volume, without disturbing
others.
•
[On] – Enjoy quiet viewing at night.
•
[Off] – Enjoy surround sound with a full
dynamic range.
Note
•
Applicable only to Dolby Digital encoded DVD.
Video setup
Video Setup
TV System
TV Display
Progressive
Picture Setting
1
Press SETUP .
» [General Setup] menu is displayed.
2
Press
to select [Video Setup] , then press
.
3
Select an option, then press OK .
4
Select a setting, then press OK .
•
To return to the previous menu, press
.
•
To exit the menu, press
SETUP .