Cisco Catalyst 3110G Getting Started Manual page 9

Follow these steps:
Remove the acoustic attenuation module, if one is installed, from the rear of the blade
Step 1
enclosure.
Select the blade enclosure bay in which to install the switch module (Figure 4).
Step 2
Figure 4 IBM BladeCenterH Rear-Panel View
1
2
I/O module bay 1
1
I/O module bay 2
2
Remove the filler module from the selected bay. Store the filler module for future use.
Step 3
If you have not already done so, touch the static-protective package that contains the switch
Step 4
module to any unpainted metal surface of the blade enclosure or any unpainted metal surface
on any other grounded rack component for at least 2 seconds.
Remove the switch module from its static-protective package.
Step 5
3
4
I/O module bay 3
3
I/O module bay 4
4
9