PEUGEOT 108 Handbook page 89

Switching on
F Press the end of the control stalk: the
speed limiter mode is selected but is not
switched on.
F Switch the speed limiter on by pulling the
control stalk towards you, if the speed
displayed is suitable (by default, the last
speed programmed).
Downloaded from www.Manualslib.com
Pause
F You can temporarily stop the the speed
limiter by pulling the control stalk towards
you again: the display confirms that it has
been stopped (Pause).
F Pull the control stalk towards you again to
restore the speed limiter.
manuals search engine
Adjusting the speed limit
setting
You do not have to switch the speed
limiter on in order to set the speed.
Once the function is selected, you can modify
the speed setting by:
- by pushing the control stalk up to increase
the setting,
- by pushing the control stalk down to
decrease the setting.
A brief push on the control stalk modifies the
speed setting by + or - 1 km/h.
A maintained push on the control stalk modifies
the speed setting by + or - 5 km/h.
Driving
5
87