Fuel And Evaporative Emissions Control System - HUSTLER MDV Operator's Manual

A
FUSE SIZE
REF.
(AMPS)
A 100 Main power circuit fuse (all vehicle except
glo plugs function)
B 100 Glo plugs (engine pre-heat)
C 150 Starter power / battery charging
NOTE: These are AMI style fuses.
Figure 4-7
A
B
B
A. Fuse box cover
B. Yellow clips
Figure 4-8
In-line Fuse
This vehicle has a 10 AMP in–line fuse integrated into the
electrical system. It is located next to the dash under the
front hood. Figure 4-8
This fuse protects the start interlock, fuel solenoid, gauges,
and pre-heat module which are on during engine cranking.
Figure 4-8
REV A
B
C
DESCRIPTION
C
C. In–line fuse housing
FUSE SIZE
REF.
(AMPS)
1 30 Power steering
2 20 Radiator fan
3 20 Radiator fan / temperature switch
4 20 Horn / headlight / front differential
5 20 Auxiliary power (dash)
6 20 Power point
7 10 Alternator exciter
8 10 Transmission speed sensor / rear differential
actuator
9 20 Auxiliary power (under the hood)
10 20 Spare fuse
11
12
NOTE: These are blade type fuses.
NOTE: Fuse block orientation may differ from one shown.

Fuel and Evaporative Emissions Control System

IMPORTANT: Refer to the Safety Precautions section of this
manual for fuel handling safety information.
The fuel and evaporative emissions control system for this
vehicle is EPA compliant. Use only Hustler
replacement parts.
Your evaporative emission control system may include
parts such as:
• fuel tank
• fuel lines
4-4
9 6 3
8 5 2
7 4 1
10
DESCRIPTION
Figure 4-9
®
approved
606653