Pre-Operation Check; Operation - HUSTLER MDV Operator's Manual

• When an accessory is not being used disconnect
it from the outlet.
• Do not connect any device that draws more than
120 watts.
• Do not use as a cigarette lighter.
• Do not use when wet.
• Close the cap when the outlet is not being used.
B. Glove box cover and latch knob
Figure 3-10
B. Glove box (Figure 3-10) — to gain access to the glove
box, rotate the latch knob clockwise and open the
cover. To close the cover, push up on it and rotate the
latch knob counterclockwise to latch it.

Pre-Operation Check

Inspect and verify that the vehicle is in proper
operating condition before operation. Failure to do
so increases the risk of an accident.
Always perform the pre-operation check before oper-
ating to make sure the vehicle is in proper operating
condition.
To avoid serious injury, check and service the vehi-
cle:
• on a level surface with engine off.
• with the parking brake engaged.
• with attachments lowered to the ground.
Before daily operation it is a good idea to get in the habit of
checking the following items to prevent mechanical/electri-
cal issues.
– Do a walk around inspection of the vehicle.
– Check the following:
• engine oil level
• coolant level
• brake pedal
REV A
B
• parking brake
• instrument panel lights and gauges
• head lights
• Occupant Protective Systems
• joint boots
• tire pressure
• fuel level
• danger and warning decals

Operation

General Operation Information
To operate the vehicle without accident or injury, the opera-
tor should understand how the vehicle will react in any situa-
tion, especially during conditions that could cause the
vehicle to overturn. Vehicle speed, cargo load, towed vehicle,
and environmental conditions play a major part in most vehi-
cle overturn incidents.
This operator's manual sets forth some of the risks, but the
list is not all inclusive. It is the operator's responsibility to be
alert for any equipment or environmental condition that
could compromise low risk operation.
For more detailed safety information refer to the Safety Pre-
cautions section of this manual.
This vehicle is designed to carry up to two people, includ-
ing the driver, at one time. All occupants must ride in the des-
ignated seating positions and use the seat belts properly.
Only individuals age 16 and older are authorized to ride or
operate this vehicle.
Engine Starting
Start the engine by following these steps. If you encounter
difficulty, contact your Hustler
1. Before starting the engine the operator should be
seated in the driver position. Secure the door properly
(if equipped).
2. Move the park brake lever to the down position (park
brake is engaged).
3. Place the gear select lever in the "NEUTRAL" position.
4. Insert the key in the ignition switch and rotate it to the
"PRE-HEAT/RUN" position. It will take approximately
two seconds before the glo-plug light will come on.
Wait for the glo-plug light to go off.
Preheating is necessary only when the temperature is
cool or cold. This operation is not necessary when
restarting a warm engine. Standard preheating times
for various temperatures are shown in the chart below.
Failure to follow these recommendations can lead to
premature failure of the starter motor and the fuel shut-
off solenoid.
IMPORTANT: Ether, or other starting fluids, must never
be used as a starting aid with this engine. Warranty
3-4
Dealer.
®
606653