Table of Contents
Advertisement
Onboard Graphics
The X10SRH-CLN4F provides onboard grpahics with a AST 2400 graphics control-
ler.
1-3
Server Chassis Features
The SC826BE1C-R920LPB is a 2U form factor chassis designed to be used in a
storage configuration. The following is a general outline of the main features of the
SC826BE1C-R920LPB chassis.
System Power
The SC826BE1C-R920LPB features a redundant 920W power supply composed of
two separate power modules. This power redundancy feature allows you to replace
a failed power supply without shutting down the system.
Hard Drive Subsystem
The SC826BE1C-R920LPB chassis was designed to support 12 hot-swap hard
drives. Two 2.5" rear-mounted, hot-swap drive bays are available as an option for
use with the onboard SATA controller (MCP-220-82609-0N). These drives install
between the power supplies and the I/O panel (see Figure 6-1).
Front Control Panel
The control panel on the SC826BE1C-R920LPB provides you with system monitor-
ing and control. LEDs indicate system power, HDD activity, network activity, system
overheat and power supply failure. A main power button and a system reset button
are also included.
Cooling System
The SC826BE1C-R920LPB chassis includes three 8-cm hot-plug system cooling
fans located in the middle section of the chassis. An air shroud channels the airflow
from the system fans to efficiently cool the processor area of the system. Each
power supply module also includes a cooling fan.
1-3
Chapter 1: Introduction
Advertisement
Table of Contents
