Drive Label Warning Example - YASKAWA Z1000 Technical Manual

i.2 General Safety
Geared Motor
Make sure that the gear and the lubricant are rated for the desired speed range to avoid gear damage when operating at low
speeds or very high speeds. Consult with the manufacturer for applications that require operation outside the rated speed range
of the motor or gear box.
Single-Phase Motor
Variable speed drives are not designed to operate with single phase motors. Using capacitors to start the motor causes a high-
frequency current to flow to the capacitors and can damage the capacitors. A split-phase start or a repulsion start can burn out
the starter coils because the internal centrifugal switch is not activated. The drive is for use with three-phase motors only.
Motor with Brake
Take caution when using the drive to operate a motor with a built-in holding brake. If the brake is connected to the output side
of the drive, it may not release at start due to low voltage levels, so be sure to install a separate power supply for the motor
brake. Note that motors with built-in brakes tend to generate a fair amount of noise when running at low speeds.
u

Drive Label Warning Example

Always heed the warning information listed in
20
Figure i.1 in the position shown in
WARNING
Risk of electric shock.
Read manual before installing.
●
Wait 5 minutes for capacitor
●
discharge after disconnecting
power supply.
To conform to requirements,
●
make sure to ground the supply
neutral for 400V class.
After opening the manual switch
●
between the drive and motor,
please wait 5 minutes before
inspecting, performing
maintenance or wiring the drive.
Hot surfaces
Top and Side surfaces may
●
become hot. Do not touch.
Figure i.1 Warning Information Example
YASKAWA ELECTRIC SIEP YAIZ1B 01E YASKAWA AC Drive – Z1000 Bypass Technical Manual
Figure i.2.