ELNA E9020 Service Manual page 5

Table of Contents

Advertisement

9. Pattern selection
Direct selection of patterns through a transparent touch panel and indication of selected pattern on LCD.
10. Number of patterns
Practical patterns 53, Continuous patterns 34, Adherence one point 34, One point 168, Lettering characters 4 fonts 450, large pattern 31, practical one point 51
11. Constant-position needle bar stopper
The machine stops with its needle up or down using the synchronizer shield plate and detector (photo-interrupter) mounted on the main shaft.
When the thread trimming presser is raised, when the embridering device is used or when the bobbin is to be wound, the machine stops with its needle up. In a case
other than those described above, the machine stops with its needle down.
12. Prevention of wrong-setting of needle
It is designed so as not to insert the needle in the wrong direction.
13. Operation guide
How to operate the sewing machine, advice and how to sew are indicated on LCD.
14. Prevention of overheat of motor
If the sewing machine motor shaft is locked, the power supplied to the motor is automatically turned OFF after 1 to 1.5 seconds.
If the motor becomes extraordinarily hot in such cases as the sewing machine cotinuously runs at high speed, the thermal sensor built in the motor detects and stops
the machine operation. (The power is turned ON again after the motor has cooled down.)
15. Automatic bobbin winder
When performing the embroidering, exclusive bobbin thread can be wound to bobbin without removing bobbin. In addition, after bobbin winding, threading to bobbin
thread tension spring and thread cutting are performed. Then sewing can continue.
(6) Microcomputer and ROM
32-bit microcomputer .......... 1
Gate array ........................... 1
Flash ................................... ROM 32MB
Flash (patterns) ................... ROM 8MB
Embroidering card ............... Available from 4MB to 128MB (Smart media)
* Gate array
A large scale and original circuit is necessary for the computer sewing machine. The circuit is built in the IC which is the exclusive one produced for this model only.
(7) Outer dimensions and weight
Main unit ............................. 47.9 cm (width) X 32.4 cm (height) X 21.5 cm (depth) Weight : 12.4 kg
Main unit with case ............. 49.5 cm (width) X 33.0 cm (height) X 23.5 cm (depth) Weight : 13.7 kg
Embroidering device ........... 33.5 cm (width) X 13.0 cm (height) X 32.0 cm (depth) Weight : 2.3 kg
(8) Power consumption
Sewing machinemain unit ... North America territory: 120V 60 Hz
(Lamp only)
Mainly Europe territory: 230V 50 Hz
3

Advertisement

Table of Contents
loading

Table of Contents