Inserting Batteries Into The Remote Control; Switching On; Smart Power On/Off - Philips DVD 728 Owner's Manual

Inserting batteries into the
Remote Control
1
Open the battery cover by pressing in the tab,
then lift off the cover.
2
Insert batteries with the correct polarity as
indicated by the + and - symbols inside the
battery compartment.
3
Close the cover.
CAUTION!
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly
and kept away from children.
Using the Remote Control
Direct the remote control at the remote sensor
of the DVD Player.
Do not drop or give the remote control a shock.
Do not leave the remote control in extremely
hot or humid places.
Do not spill water or put anything wet on the
remote control.
01-29 DVD728 Eng

Switching On

1
Be sure that the DVD Player has been correctly
connected to the TV and audio equipment.
2
Switch on the TV and DVD Player.
3
Set the TV to the correct Video In channel. (eg.
EXT1, EXT2, AV1, AV2, AUDIO/VIDEO, etc.
Please refer to your TV owner's manual for
details.)
screen appears on the TV.
4
If you are using external equipment, (eg. audio
system or receiver), turn it on and select the
+
-
appropriate input source for the DVD Player
output. Refer to the equipment owner's manual
for detail.
+ -

Smart Power On/Off

When in STOP or NO DISC mode, the DVD
Player will switch to standby mode after 15
minutes without any operations for saving energy.
It is easily reactivated by pressing the POWER or
PLAY key on the remote control or the
STANDBY-ON button on the front panel.
11
Preparation
The Player display lights up and the default
3139 246 12921
18/03/2003, 4:50 PM
11