Advertisement
10. Error check
Confirm the following items when it seems that the FX
1) Confirm the state of POWER LED.
Lit
Turn off or blinks :Confirm the proper connection of the extension cable.
2) Confirm the external wiring per section "3. Wiring".
3) Confirm whether the load resistance of the connected equipment corresponds to the specification of
the FX
-2AD.
2N
4) Confirm the Voltage and Current input values with a voltage and current generator. Confirm the
analog to digital conversion from the input characteristic.
5) Readjust the offset and gain by "7. Adjustment of offset and gain" when the analog to digital
conversion is not suitable for the input characteristic.
The input characteristic when shipped from the factory is 0 to 10V DC.
Guidelines for the safety of the user and protection of the FX
FUNCTION BLOCK
•
This manual has been written to be used by trained and competent personnel. This is defined
by the European directives for machinery, low voltage and EMC.
•
If in doubt at any stage during the installation of the FX
electrical engineer who is qualified and trained to the local and national standards. If in doubt
about the operation or use of the FX
representative.
•
Under no circumstances will Mitsubishi Electric be liable or responsible for any consequential
damage that may arise as a result of the installation or use of this equipment.
•
All examples and diagrams shown in this manual are intended only as an aid to
understanding the text, not to guarantee operation. Mitsubishi Electric will accept no
responsibility for actual use of the product based on these illustrative examples.
•
Owing to the very great variety in possible application of this equipment, you must satisfy
yourself as to its suitability for your specific application.
This manual confers no industrial property rights or any rights of any other kind, nor does it
confer any patent licenses. Mitsubishi Electric Corporation cannot be held responsible for any
problems involving industrial property rights which may occur as a result of using the contents
noted in this manual.
Warranty
Exclusion of loss in opportunity and secondary loss from warranty liability
Regardless of the gratis warranty term, Mitsubishi shall not be liable for compensation to:
(1) Damages caused by any cause found not to be the responsibility of Mitsubishi.
(2) Loss in opportunity, lost profits incurred to the user by Failures of Mitsubishi products.
(3) Special damages and secondary damages whether foreseeable or not, compensation for
accidents, and compensation for damages to products other than Mitsubishi products.
(4) Replacement by the user, maintenance of on-site equipment, start-up test run and other tasks.
This product has been manufactured as a general-purpose part for general industries, and has
not been designed or manufactured to be incorporated in a device or system used in purposes
related to human life.
Before using the product for special purposes such as nuclear power, electric power,
aerospace, medicine or passenger movement vehicles, consult with Mitsubishi Electric.
This product has been manufactured under strict quality control. However when installing the
product where major accidents or losses could occur if the product fails, install appropriate
backup or failsafe functions in the system.
HEAD OFFICE : TOKYO BUILDING, 2-7-3 MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
JY992D74701G
:The extension cable is correctly connected.
Manual number : JY992D74701
Manual revision : G
Date
-2AD does not operate normally.
2N
-2AD always consult a professional
2N
-2AD please consult your local Mitsubishi Electric
2N
For safe use
: December 2016
Specifications are subject to change without notice.
-2AD SPECIAL
2N
Effective December 2016
Advertisement
