Reading Procedure; Fitting The Probe Caps; Switching On The Appliance And Taking Readings - Chicco comfort quick User Manual

as the use of hot or cold water will affect
the reading.
• Do not take a person's temperature for at
least thirty minutes after physical effort,
a bath or after a meal.
• If the probe is pointed at a hot object,
it will perform a remote temperature
reading. To avoid such reading errors,
keep the time from when it is switched
on to when it takes the ear reading to a
minimum.
• Do not touch the sensor, the probe or
the probe cap with your fingers. If fin-
gerprints get left on the sensor, remove
them following the instructions provided
in the "CARE AND MAINTENANCE"
section.

READING PROCEDURE

Important: before switching the appli-
ance on, the probe cap must be fitted
correctly, following the instructions
provided in the "Fitting the probe cap"
section.

Fitting the probe caps.

1. Place the probe cap in the hous-
ing in the thermometer case (see
diagram 1). Important: position the
probe cap making sure the adhesive
part, i.e. the knurled section, (see
diagram 1 ) is facing upwards.
2. Align the centre of the probe cap
with the centre of the probe.
3. Insert the probe into its seat until
you hear it click into place; this
mean it is now ready to use.
If the probe cap is not fitted correctly,
when the appliance is switched on,
the symbol will blink on the dis-
play and it will not be possible to take
any readings (the appliance will beep
four times and no message will ap-
pear on the display).
If this happens, fit the probe cap again
following the instructions provided in
points 1-3 of this section very care-
fully.
Warning! Only use dedicated probe
caps REF 00001205000000
Switching on the appliance and
taking readings
Press the
the left side of the appliance.
When the appliance is switched on, it
will run an autotest and all the seg-
ments on the display will light up.
If any segments do not light up, do
not use the thermometer under any
circumstances.
When the autotest sessions has been
completed, the thermometer display
will look like the picture in diagram 4
The thermometer is ready for use as
soon as the (ear) icon stops blinking
and the appliance beeps twice.
Fig. 1
If an error message appears on the
display, please refer to page 19.
Important: Before taking a reading,
always make sure that the sensor is
clean and has not been damaged in
any manner; also check that the ear
canal is perfectly clean too. Now press
14
Fig. 2
(ON/MEM) button on
Fig. 3
Fig. 4
the
the
Ho
1. G
t
v
t
m
ra
• Fo
ge
• Fo
an
w
2. P
r
in
w
m
t
o
No
con
tem
No
ear
the
dep
tym
On
cor