Menu System Navigation - Generac Power Systems 8 kVA Owner's Manual

Operation

Menu System Navigation

To get to the MENU, use the ESCAPE button from any page. You may need to press the ESCAPE button several times
before reaching the MENU page. Navigate to the desired menu by using the
displayed and flashing, press the ENTER button.
EVOLUTION/SYNC2.0 HSB MENU MAP
Note: Menu functions and features may vary
depending on unit model and firmware revision.
Running Manual
Running-Utility Lost
Running-Remote Start
Running-2 Wire Start
Running - Exercise
Switched Off
Stopped - Auto
Stopped - Alarm
- 1 thru 50 +
- 1 thru 50 +
Warning Message(s)
Charger Warning
Charger Missing AC
Low Battery
Battery Problem
Exercise Set Error
USB Warning
Download Failure
Alarm Message(s)
High Temperature
Low Oil Pressure
Overcrank
Overspeed
Overvoltage
Undervoltage
Overload
Underspeed
RPM Sensor Loss
Controller Fault
Wiring Error
Stepper Overcurrent
Fuse Problem*
*"Fuse Problem" on Firmware
1.11 and older ONLY
12
Battery Condition
"Good" "Inspect Battery" or "Check Battery"
ENTER ENTER
- Run Log +
ESC ESC
- Alarm Log +
ENTER ENTER
Language
ESC
English
Fuel Selection
ESC
NG or LP
Set Output Voltage
ESC
- 220/230/240 +
Cold Smart Start?
ESC
YES or NO
Current Date/Time
ESC
02/14/16 07:40
(mm/dd/yy hr:min format)
Exercise Time
ESC
14:00 Wednesday
Firmware Update
ESC
Press Enter
Figure 3-6. Navigation Menu
↑ ↓
/ buttons. When the desired menu is
ENTER
ENTER
ESC
"Run Log"
"Alarm Log"
ENTER
ENTER
Language
+ English -
ENTER
Fuel Selection
+ NG or LP -
ENTER
Set Output Voltage
- 220/230/240 +
ENTER
Cold Smart Start?
- YES or NO +
ESC
ENTER
Select Hour (0-23)
- 14 +
ESC
ENTER Select Frequency
- WEEKLY +
- BIWEEKLY +
- MONTHLY +
ENTER
Firmware Update
ESC
Insert USB
Owner's Manual for 50 Hz Air-Cooled Generators
Switched to "OFF"
Hours of Protection
0 (H)
ESC
SYSTEM DATE/TIME
BAT- SUB MENUS
ENTER ESC
ENTER
HISTORY
ESC
Language
+ +
- + Espanol - -
ESC
ESC
ESC
ESC
ENTER
Select Min (0-59)
- 0 +
+
ENTE