Onkyo HT-RC260 (B) Service Manual page 10

MMPU/ VMPU/ DSP Update Procedure-2
Update Procedure
While the unit is on, hold down [DISPLAY] and then press [ON/STANDBY].
1.
Main FW Version will be shown on Front Display.
e.g.
M:1.02/10323AE
2.
While Main FW Version is shown, press [+(TONE)].
DSP FW Version will be shown on Front Display.
e.g.
D:1.02 /1 0 4 1 6 a 3 8
3.
While DSP FW Version is shown, press [RETURN].
A UT O
* TUNING key changes "AUTO
（"AUTO" means "COAX1" or "OPT1" will be automatically detected.
* TUNING key changes "ALL MMPU
（TOTAL = MMPU+VMPU+DSP+VSP+PORT）
4. When MMPU VMPU and DSP FWs are upgraded at the same time, select
*The FW data please use Package Wev file.
S/PDIF Update..
5. PC upgrade: Play back the stored wav file in your PC.
CD upgrade: Play back the FW CD-R with the connected CD player.
[NOTE] Make sur e th at
About 20 se cond s la t er , th e me ssag e w i ll c h a n g e f r o m
When "Writing..." will not be shown, the output music data is not correct.
Check the connection and settings.
S/PDIF Update..
DSP Writing...
VMPU Writing
M M P U Se tti n g
FW-Update 00000
FW-Update FF000
OK:Sum=
6. Unplug AC cord and plug it again. Press
C le a r
7. Make sure that "Clear" is shown and the unit is turned into the Standby mode.
8. Make sure that the FW versions are the latest.
TX-SR578/ 608 HT-R680/ 980/ C260 DTR-20.2/ 30.2
* It depends on the version.
* It depends on the version.
A L L
COAX1 OPT1."
VMPU
For separate upgrade, select
and please "ENTER."
*The partial renewal cannot use Package Wev file.
Please use individual Wav File.
"d o l b y d ts" i s show n bef o r e st a r t in g p l a yb a ck .
P la yba ck sta rts. (Pl ayback time: a bout
(about 20 seconds)
After playback finishes, update will start.
(just after "FF000" is shown)
"********" depends on the version.
*************
[ON/STANDBY].
ON/STANDBY
+(TONE)
DSP VSP PORT".
"AUTO
"MMPU" "VMPU" or
It takes about 15 minutes.
S/PDIF Update...
TUNING
DISPLAY ENTER
RETURN
ALL" and press "ENTER."
"DSP"
to Writing...
20 minutes
)