Philips L06.1E AA Service Manual page 10

EN 10 4.
4.4 Assy / Board Removal
Sometimes, it can be necessary to swap a complete assy or
Printed Wiring Board (PWB). How that can be done is
explained below.
4.4.1 Top Control & Side I/O Assy/Panel
Figure 4-3 Top control & Side I/O assy/panel
1. Remove the two fixation screws that hold the panel (see
Figure "Top control & Side I/O assy/panel").
2. Pull the board backwards and remove it from the TV set.
3. Remove, if necessary, all the connectors from the board.
4.4.2 Mains Switch/LED Panel
2
3
Figure 4-4 Mains Switch / LED panel
1. Release the two fixation clamps [1] by pushing them
backwards and upwards (see Figures above).
2. Pull the complete assy backwards [2].
3. If the board has to be removed, release the two clamps at
the sides of the bracket and lift the panel out [3].
L06.1E Mechanical Instructions
G_16350_046.eps
1
1 1
3
G_16350_064.eps
4.4.3 Small Signal Board (SSB)
Figure 4-5 SSB removal from chassis
060406
1. Release the fixation clamp (see Figure "SSB removal from
chassis") by pushing it backwards.
2. Take the complete SSB out.
3. If the board has to be removed, release the two clamps at
the sides of the bracket and lift the panel out (see Figure
"SSB removal from bracket").
070406
Figure 4-6 SSB removal from bracket
G_16350_048.eps
060406
G_16350_049.eps
060406