Disassembly - JVC XV-NP1SL Service Manual

There is a part different from the photograph according to the model and the destination though explains this disassembly method by
using XV-NP1SL for europe.
3.1 Main body section
3.1.1 Removing the top cover (See Figure 1)
(1) Remove the two screws A attaching the top cover on both
sides of the main body.
(2) Remove the three screws B attaching the top cover on the
back of the main body.
(3) Raise the both sides and lower part of the rear of the top
cover, with opening them slightly in an outward direction.
And the top cover will be removed.
3.1.2 Removing the front panel assembly (See Figure 2, Figure 3, Figure 4)
• Prior to performing the following procedure, remove the top
cover.
• There is no need to remove the mechanism assembly.
(1) Insert a kind of screwdriver in a hole located in the right
side of mechanism assembly, and push a lever until it can-
not be inserted any further.
(2) And then, a tray will come out. Remove the tray in an upper
direction, with slightly opening the lower part of fitting in an
outward direction.
(3) Disconnect the card wire from connector
power supply board.
(4) Disconnect hte card wire from connector
memory card reader board.
(5) Remove the one screw C attaching the bracket.
(6) Hook a and b are removed respectively, and the front panel
assembly is removed.
Fitting
Push Push
SECTION 3

DISASSEMBLY

CN901
CN831
Front panel assembly
Mechanism assembly
Tray
Hole and lever
Fig.2
A
2
x
Memory card reader board
CN831
C
on the
on the
Front panel
Hook b
assembly
Hook a
TOP COVER TOP COVER TOP COVER
B
B
Fig.1
Front panel assembly
CN901
Power supply board
Fig.3
Hook a
Hook b
Hook b
Fig.4
(No.XA004)1-9
B