Intex krystal clear 636T Owner's Manual page 8

FILTER PUMP HOSE CONNECTION SETUP
1. Remove the Krystal Clear™ filter pump and hoses from the packaging.
2. Place the filter pump in such a manner, that you can easily assemble the hose (7)
connections to the plunger valve.
Note: Some regional regulations may require the filter pump to be mounted on a
stationary platform. There are two mounting holes located in the pump base for this
reason. Consult your local authorities for filter-pump mounting requirements.
3. Grasp the two pump hoses (7) and connect the hose nuts to the filter pump.
4. In a counter-clockwise motion unscrew the threaded filter housing collar (1) from the filter
housing. Place it in a safe place.
5. The filter pump is an airtight system. Turn the top air release valve (2) once or twice in a
counter-clockwise motion. DO NOT remove the air release valve from the top cover, as
water will expel with force if the motor is turned on. This may cause injury.
6. Grasp and remove the filter housing cover (4). Check to see if a cartridge is inside the
housing. If yes, replace the cover, finger tighten the housing collar (1) back onto the filter
housing.
7. Gently finger tighten the sediment release valve located at the bottom of the housing to be
sure that water does not leak out.
8. When the pool is filled connect the hose from the bottom of the filter housing to the highest
strainer assembly. You will find the hose connection at the bottom of the plunger valve
assembly. Use the hose nut to attach the hose.
9. Connect the second hose which is fixed to the middle of the motor housing to the
remaining liner connection.
Position this product away from the pool, so as to prevent children from
climbing on it and accessing the pool.
FILTER HOUSING
AIR RELEASE
VALVE
MOTOR
HOUSING
The installation instruction shall provide information on requirements specified for the electrical
installation and shall include reference to national wiring rules.
SAVE THESE INSTRUCTIONS
(108) MODEL 636T FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 04/21/2014
WARNING
PLUNGER VALVE
ASSEMBLY
HOSE NUT
COVER
OUTLET HOSE
THREADED FILTER
HOUSING COLLAR
FILTER CARTRIDGE
INSIDE
HOSE
O-RING
HOSE O-RING
INLET HOSE
POWER CORD
English
WATER LEVEL
ADJUSTABLE POOL
INLET NOZZLE
INSIDE LINER
WALL
THREADED
STRAINER
CONNECTOR
OUTSIDE LINER
WALL
(ILLUSTRATION NOT TO SCALE)
108A
Page 8