Operating Instructions - Intex krystal clear 636T Owner's Manual

OPERATING INSTRUCTIONS

1. Make sure the filter pump is switched off. The switch is located on the motor housing.
2. Connect the power cord to a GFCI protected electrical outlet.
Risk of electric shock. Connect this product only to a grounding type
receptacle protected by a ground-fault circuit interrupter (GFCI) or
residual current device (RCD). Contact a qualified electrician if you
cannot verify that the receptacle is protected by a GFCI/RCD. Use a
qualified electrician to install the GFCI/RCD, which has a maximum rate
of 30mA. Do not use a portable residual current device (PRCD).
To prevent air lock, open the lower plunger valve (connected inlet hose) first and
then the upper plunger valve (connected outlet hose). Open the air release valve,
wait until water starts to flow out of the air release valve, close air release valve.
3. Turn both plunger valve handles fully counter-clockwise until they stop. This opens the
valve, allowing water to flow into the filter pump.
4. With water flowing into filter pump, the water pressure will allow the air trapped inside to
escape from the air release valve (2). When all the air has escaped water will flow out of the
valve (2). When this occurs gently finger tighten the valve (2) in a clockwise direction.
5. To operate the filter pump on "TIMER" mode:
A. Set the timer dial to the desired operating hours. See operation time table. See Fig. 10
B. Turn on the pump by pressing the switch to "
the water and will stop after the operating hours are completed. The built-in timer will
now operate for the number of hours selected at the same time each day.
C. Operating hours can be re-adjusted if necessary. Follow step A – B.
To operate the filter pump manually (without the "TIMER" mode):
A. Turn on the pump by pressing the switch to "-" position, the filter pump is now filtering
the water.
B. To turn off the pump, press the switch to "O" position.
6. Never put pool chemicals directly into the filter pump. This may damage the pump and void
the warranty.
SAVE THESE INSTRUCTIONS
(108) MODEL 636T FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 04/21/2014
WARNING
IMPORTANT
" position, the filter pump is now filtering
TIMER DIAL (HOURS)
ON
FIG 10
English
6
OFF TIMER
Page 10
108A