Intex krystal clear 636T Owner's Manual page 7

POOL INLET - NOZZLE & PLUNGER VALVE SETUP (optional)
1. In a counter-clockwise motion unscrew
plunger valve union from the threaded
strainer connector (13) (see drawing 5).
Be careful not to lose the step rubber
washer (10). Place the plunger valve on
the ground in a safe place.
2. In a counter-clockwise motion unscrew
the strainer nut (11) from the threaded
connector (13). Leave the flat
washer (12) on the connector (13).
3. Install the nozzle and plunger valve at the
upper position of the pool inlet. From the
inside of the pool liner insert the
connector (13) into one of the pre-cut
holes with the washer remaining on the
connector to be placed against the
inside of the liner wall.
4. Before assembly, lubricate the threads
with a petroleum jelly. Then, with the flat
side of the strainer nut (11) facing the
outside wall of the liner in a clockwise
motion screw the strainer nut (11) back
onto the threaded connector (13) (see
drawing 6).
5. Finger tighten the adjustable pool inlet
nozzle (14) and the strainer nut (11) onto
the threaded connector (13).
6. Grasp the plunger valve assembly. Make
sure the step washer (10) is in place.
7. In a clockwise motion screw the plunger
valve union back onto the threaded
connector (13) (see drawing 7).
8. In a clockwise motion turn the plunger
valve handle to close position. Ensure the
plunger valve is securely closed. This will
prevent water from flowing out during
filling of the pool (see drawing 8).
9. Adjust the direction of the nozzle head
pointing away from the pool outlet for a
better circulation result (see drawing 9).
10. The pool liner is now ready to be filled
with water. Consult the
above-ground-pool owner's manual for
the filling instructions.
SAVE THESE INSTRUCTIONS
(108) MODEL 636T FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 04/21/2014
11
English
108A
5
2
1
6
INSIDE
LINER WALL
12 13 14
7
1
2
8
INSIDE
LINER WALL
9
Pool
WATER
FLOW
Page 7