Table of Contents
Advertisement
How to install the Product.
Initial installation.
1. Select the location of usage.
Unfold mattress and place it on a desired location (Bed, floor)
Keep boiler more than 1 ft (30 cm) away from the mattress and place
in a secure location.
2. Connect the hosepipe to the mattress.
Straighten hosepipe in the mattress to prevent restriction of water flow.
Attach the connector from the hosepipe, which is attached to the
mattress, to water outlet/inlet on back side of the boiler, with the
connector button facing upward.
Push the connections together until you hear a 'click' .
3. Press the power button on the boiler.
Connect power cord of the boiler to an outlet before pressing the
power button.
4. Inject water
Total amount of water injection inside the product is 1,000 ml
for Queen-type products (800 ml for single-type)
Follow the proecdure for injecting the water into the system,
open stopper.
Follow guidance to water injection order, and continue to check
on the water level lamp as you slowly inject the water into the inlet.
When the product indicates that enough water has been injected,
stop injecting water and hold for a moment.
When you are asked to inject water again, repeat process
twice.
When completion of water injection is announced again, stop
injecting water, screw close clockwise until there is a click sound,
and cover the water inlet.
If water level touches safety net inside water inlet, water may overflow:
Be careful to keep water level low enough to prevent it from touching
the safety net.
If you inject too much water after announcement of completion of
water injection, water could leak through the small air holes
on the stopper.
It is recommended that water be filled higher than medium water
level for continuous and safe heating.
Please only use purified water or filtered water.
Do NOT use ground water, sea water, or saline solution.
5. Start operating by setting desired temperature.
Refer to 'How To Use the Product' for setting the temperature.
When re-supplementing water during operation
Follow the procedures for injecting the water and slowly perform water injecting processes as stated in part 4.
There can be water remaining inside the mattress when re-supplementing water during operation,
so, be careful of water overflow.
2
1
2
and
click!
click!
15
Hide quick links:
Advertisement
Table of Contents
