JVC UX-G35US Service Manual page 16

3.2.3 Removing the traverse mechanism assembly
(See Fig.4)
(1) Remove the four screws C attaching the traverse mecha-
nism assembly from bottom side of CD mechanism assem-
bly.
(2) Disconnect the card wire from connector
servo board and then take out the traverse mechanism as-
sembly and CD servo board together.
Reference:
When reattaching the traverse mechanism assembly, the card
wire should through the part d.
1-16 (No.MB536)
CN602 of the CD
CD mechanism assembly
CD servo board
Card wire
d
C
Traverse mechanism assembly
Fig.4
C
CN602